Wahoo Stride Sensor

Compatible with: iPhone paired with Wahoo Key or Wahoo Bike Case, or any ANT+ receiving device (Key and Case not included)
Part#: WFFP01
Collect cadence and speed data while running. Attach to the laces of your shoes and pair with the Wahoo Key or Wahoo Bike Case to start analyzing your running data.

Features:

• Wireless
ANT+ ultra low power technology license free, 2.4 GHz ISM band operation
• Utilizes two, high precision 3-axis accelerometers for the most accurate, real-time distance precision
• Suitable for running, walking and hiking on any type of terrain
• Easy, secure attachment to shoelaces with included lace cradle
• Water resistant up to 5 feet
• Sends/Receives signals up to 10 feet unobstructed
• Replaceable 3 volt coin cell battery (CR2032)

Your Wahoo Fitness Stride Sensor is a device worn on your shoe which uses a 3-axis accelerometer to determine your distance and speed while walking, running or hiking.

How do I use it?
Before shoe laces are tightened, slide Cradle under two or three sets of crossing laces (depending on eyelet spacing) near the toe. The narrow end of the cradle should be pointing toward the toe. Tighten laces. It does not matter if the Stride Sensor is on the left or right shoe. Snap the Stride Sensor into the cradle so that the laces are sandwiched between the Cradle and the Sensor. Ensure the Stride Sensor ‘snaps’ securely into place at all four connection points and the narrow end of the sensor is pointing toward your toes. Once in place, move within 5’ - 10’ of any device that receives ANT+ wireless data.

How do I wake the sensor up?
Your Stride Sensor ‘sleeps’ with inactivity and ‘awakens’ when readings begin so a few steps may be required before the sensor begins emitting data.

How do I pair and calibrate it with my device?
Each Wahoo Fitness Sensor has a unique identification code and can be uniquely paried with a display device or reader so that it will always be recognized when it is activated and within range. In addition, your Stride Sensor can be calibrated for greater accuracy. Since each reader is unique, you should reference the instructions of your reader for pairing and calibration techniques.

How do I change the battery?
The battery in your Wahoo Fitness Stride Sensor is located behind a cover on the back of your Stride Sensor and can be replaced by placing a coin in the slot and turning the cover 1/4 turn counterclockwise. Replace with a 3 volt CR2032 battery (contact a local waste handling group for proper disposal of old battery). Wait 45 seconds before installing the new battery to ensure the electronics fully reset.